Sword Pinstriping brushes series 20 American Favorite
Sword Pinstriping brushes series 20-America's Favorite by the Andrew Mack Brush Company. This Pinstriping and Touch-up brush is used by all leading Body Shops for Touch-up and full long line pinstriping. This Sword Pinstriping brushes series 20 is the best for all around work. Execellent for auto body touch-up and pinstriping. Used by pinstripers and sign painters everywhere. European dressed squirrel hair pinstriper brushes with a wooden handle that's lacquer, enamel and water resistant. The series #20 has Dark Green Thread Ferrule and all Hair Lenght out is 2" or 5.08cm, comes in six sizes, available in size 00 (Head Width 7/32"or 5.55mm), size 0 - (Head Width 1/4"or 6.35mm), size 1 (Head Width 5/16"or 7.93mm), size 2 (Head Width 13/32"or 10.31mm), size 3 (Head Width 1/2"or 12.70mm), size 4 (Head Width 1/2"or 14.28mm) and size 5 (Head Width 5/8"or 15.80mm). Individual Sword-Pinstriping brushes series 20 listed below.
Sword Pinstriping Brush Cleaning and Care: Always clean out pinstriping brushes well using the proper solvent or thinner for the paint your using. Some cleaning agents that contain more than 5% Methonal can attack the glues for the threads holding the pinstriping brush hairs to the wooden handle, in simple terms, Methonal can ruin the brushes. After a good cleaning, store brushes used in oils or solvent in Brush Oil to keep the hair relaxed and to prevent any paint that is trapped in the hilt/ferrule of the brush from drying. Brush oil can be cleaned out with Mineral Spirits, Turpentine and if need my may use Laquer thinner before using the pinstriping brush the next time.
Brush Tips by Ron Percell, I always use refined Lard Oil as a brush preservative to get the most life out of my Brushes. I ran across a old sign kit of mine that had been stored for 15 years and the refined Lard oil was still fresh. Before I used some of those vegtable based products and they would dry and crystalize in 3-6 month, it took some serious soaking to get the stuff out of the brushes. Over the years of making professional chemicals for the sign painting industry I've learned that those few waterbased (plant based) oils are natural Varnishes, now tell me, would you leave varnish in your brushes, I don't think so. Avoid automotive oils, they have detergents which eat at the hairs. In a pinch, mineral oil will for a short time but isnt thick enough, so stick with refined Lard Oil like the Old Timers did...
